XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
38-7
finish the DHCP protocol procedure. If the DHCP option 82 is disabled, DHCP server cannot
distinguish that whether the DHCP client is from the network connected to Switch1 or Switch2.
So, all the PC terminals connected to Switch1 and Switch2 will get addresses from the public
address pool of the DHCP server. After the DHCP option 82 function is enabled, since the
Switch3 appends the port information of accessing Switch3 to the request message from the
client, the server can tell that whether the client is from the network of Swich1 or Swich2, and
thus can allocate separate address spaces for the two networks, to simplify the management
of networks.
The following is the configuration of Switch3(MAC address is 00:03:0f:02:33:01):
Switch3(Config)#service dhcp
Switch3(Config)#ip dhcp relay information option
Switch3(Config)#ip forward-protocol udp bootps
Switch3(Config)#interface vlan 3
Switch3(Config-if-vlan3)#ip address 192.168.10.222 255.255.255.0
Switch3(Config-if-vlan2)#ip address 192.168.102.2 255.255.255.0
Switch3(Config-if-vlan2)#ip helper 192.168.10.88
Linux ISC DHCP Server supports option 82, its configuration file /etc/dhcpd.con is
ddns-update-style interim;
ignore client-updates;
class "Switch3Vlan2Class1" {
match if option agent.circuit-id = "Vlan2+Ethernet1/0/2" and option
agent.remote-id=00:03:0f:02:33:01;
}
class "Switch3Vlan2Class2" {
match if option agent.circuit-id = "Vlan2+Ethernet1/0/3" and option
agent.remote-id=00:03:0f:02:33:01;
}
subnet 192.168.102.0 netmask 255.255.255.0 {
option routers 192.168.102.2;
option subnet-mask 255.255.255.0;
option domain-name "example.com.cn";
option domain-name-servers 192.168.10.3;
authoritative;