XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
32-3
4. Configure trusted IP
Command
Explanation
Global configuration mode
anti-arpscan trust ip <ip-address>
[<netmask>]
no anti-arpscan trust ip <ip-address>
[<netmask>]
Set the trust attributes of IP.
5. Configure automatic recovery time
Command
Explanation
Global configuration mode
anti-arpscan recovery enable
no anti-arpscan recovery enable
Enable or disable the automatic
recovery function.
anti-arpscan recovery time <seconds>
no anti-arpscan recovery time
Set automatic recovery time.
6. Display relative information of debug information and ARP scanning
anti-arpscan log enable
no anti-arpscan log enable
Enable or disable the log function of ARP
scanning prevention.
anti-arpscan trap enable [level1|level2
]
no anti-arpscan trap enable [level1|lev
el2 ]
Enable or disable the SNMP Trap function
of ARP scanning prevention.
anti-arpscan FFP max-num <num>
The maximum quantity of ARP scanning
prevention function occupied FFP item.
show anti-arpscan [trust {ip | port | s
upertrust-port | iptrust-port} | prohibit
ed {ip | port}]
Display the state of operation and
configuration of ARP scanning prevention.
show anti-arpscan ip-based attack-list
[history]
Display source information or history
source information of ARP scanning
attacks prevention.
show anti-arpscan ip-based running-c
onfig
Display the current
configuration of arp
scanning prevention.
clear anti-arpscan speed-limit< IP Add
ress>
Flush ARP limited rate for specified host
manually.
clear anti-arpscan ip-isolate<IP Addres
s>
Flush IP business isolation for specified
host manually.