XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
31-11
ipv6 nd ns-interval <seconds>
no ipv6 nd ns-interval
Set the interval of the interface to send neighbor
query message. The NO command resumes
default value (1 second).
(3) Configure static IPv6 neighbor Entries
Command
Explanation
Interface Configuration Mode
ipv6 neighbor <ipv6-address>
<hardware-address> interface
<interface-type interface-name>
Set
static neighbor table entries, including
neighbor IPv6 address, MAC address and
two-layer port.
no ipv6 neighbor <ipv6-address>
Delete neighbor table entries.
(4) Delete all entries in IPv6 neighbor table
Command
Explanation
Admin Mode
clear ipv6 neighbors
Clear all static neighbor table entries.
31.2.3 IPv6 Troubleshooting
If the connected PC has not obtained IPv6 address, you should check the RA announcement
switch (the default is turned off)
31.3 ARP
31.3.1
Introduction to ARP
ARP (Address Resolution Protocol) is mainly used to resolve IP address to Ethernet MAC
address. Switch supports static ARP configuration.
31.3.2 ARP Configuration Task List
ARP Configuration Task List:
1. Configure static ARP
1. Configure static ARP
Command
Explanation