XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
147
the port after showing the transceiver monitoring of the fiber module.
Step1: Show the transceiver monitoring of the fiber module. Both ethernet 21 and ethernet 22
do not enable the transceiver monitoring, its interval is set to 30 minutes.
Switch(config)#show transceiver threshold-violation interface ethernet 1/0/21-22
Ethernet 1/0/21 transceiver threshold-violation information:
Transceiver monitor is disabled. Monitor interval is set to 30 minutes.
The last threshold-violation doesn’t exist.
Ethernet 1/0/22 transceiver threshold-violation information:
Transceiver monitor is disabled. Monitor interval is set to 30 minutes.
The last threshold-violation doesn’t exist.
Step2: Enable the transceiver monitoring of ethernet 21.
Switch(config)#interface ethernet 1/0/21
Switch(config-if-ethernet1/0/21)#transceiver-monitoring enable
Step3: Show the transceiver monitoring of the fiber module. In the following configuration,
ethernet 21 enabled the transceiver monitoring, the last threshold-violation time is Jan 02
11:00:50 2011, the detailed DDM information exceeding the threshold is also shown.
Switch(config-if-ethernet1/0/21)#quit
Switch(config)#show transceiver threshold-violation interface ethernet 1/0/21-22
Ethernet 1/0/21 transceiver threshold-violation information:
Transceiver monitor is enabled. Monitor interval is set to 30 minutes.
The current time is Jan 02 12:30:50 2011.
The last threshold-violation time is Jan 02 11:00:50 2011.
Brief alarm information:
RX loss of signal
RX power low
Detail diagnostic and threshold information:
Diagnostic Threshold
Realtime Value High Alarm Low Alarm High Warn Low Warn
------------ ----------- ----------- ------------ ---------
Temperature（℃） 33 70 0 70 0
Voltage（V） 7.31 10.00 0.00 5.00 0.00
Bias current（mA） 3.11 10.30 0.00 5.00 0.00
RX Power（dBM） -30.54(A-) 9.00 -25.00(-34) 9.00 -25.00
TX Power（dBM） -1.01 9.00 -12.05 9.00 -10.00