XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
142
query the last abnormity status through executing the commands. When the user finds the
abnormity information of the fiber module, the fiber module information may be remonitored
after processing the abnormity information, here, the user is able to know the abnormity
information and renew the monitoring.
17.2 DDM Configuration Task List
DDM configuration task list:
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
（1） Configure the interval of the transceiver monitoring
（2） Configure the enable state of the transceiver monitoring
（3） Show the information of the transceiver monitoring
（4） Clear the information of the transceiver monitoring
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
(1) Configure the interval of the transceiver monitoring
Command
Explanation
User mode, admin mode and global mode
show transceiver [interface ethernet
<interface-list>][detail]
Show the monitoring of the
transceiver.
Command
Explanation
Port mode
transceiver threshold {default | {temperatur
e | voltage | bias | rx-power | tx-power} {hi
gh-alarm | low-alarm | high-warn | low-war
n} {<value> | default}}
Set the threshold defined by the
user.
Command
Explanation
Global mode