XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
129
8. Set the port priority of the current port in LACP protocol
9. Set the timeout mode of the current port in LACP protocol
14.5 Port Channel Examples
Scenario 1: Configuring Port Channel in LACP.
Fig 6-2 Configure Port Channel in LACP
The switches in the description below are all switch and as shown in the figure, ports 1, 2,
3, 4 of S1 are access ports and add them to group1 with active mode. Ports 6, 8, 9, 10 of S2
Global mode
lacp system-priority <system-priority>
no lacp system-priority
S
et the system priority of LACP
protocol, the no command restores
the default value.
Command
Explanation
Port mode
lacp port-priority <port-priority>
no lacp port-priority
Set the port priority in LACP protocol.
The no command restores the default
value.
Command
Explanation
Port mode
lacp timeout {short | long}
no lacp timeout
S
et the timeout mode in LACP
protocol. The no command restores
the default value.
S1
S2