XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
100
9.3 Port Configuration Example
Fig 1-1 Port Configuration Example
No VLAN has been configured in the switches, default VLAN1 is used.
Switch
Port
Property
Switch1
1/0/7
Ingress bandwidth limit: 50 M
Switch2
1/0/8
Mirror source port
1/0/9
100Mbps full, mirror source port
1/0/10
1000Mbps full, mirror destination port
Switch3
1/0/12
100Mbps full
The configurations are listed below:
SW1：
Switch1(config)#interface ethernet 1/0/7
Switch1(Config-If-Ethernet1/0/7)#bandwidth control 50000 both
SW2：
Switch2(config)#interface ethernet 1/0/9
Switch2(Config-If-Ethernet1/0/9)#speed-duplex force100-full
Switch2(Config-If-Ethernet1/0/9)#exit
Switch2(config)#interface ethernet 1/0/10
Switch2(Config-If-Ethernet1/0/10)#speed-duplex force1g-full
Switch2(Config-If-Ethernet1/0/10)#exit
Switch2(config)#monitor session 1 source interface ethernet 1/0/8;1/0/9
Switch2(config)#monitor session 1 destination interface ethernet 1/0/10
SW3：
Switch3(config)#interface ethernet 1/0/12
Switch3(Config-If-Ethernet1/0/12)#speed-duplex force100-full
1/0/7
Switch 2
Switch 3
1/0/9
1/0/12
1/0/8
1/0/10
Switch 1