User's Manual

Configuration Guide of XGS-5240-Series
59-26
2. Configure the detection interval of radius server
Command
Explanation
Global Mode
radius-server escape detection-interval
{default | <second>}
Configure the detection interval of radius s
erver and the default value is 180s.
1.1.1.35 Radius Server Escaping Examples
Fig 15-8 Radius server escaping case
The configuration is as below:
1 Configure the related authentication key, authentication server, accounting server an
d aaa mode of the RADIUS server in global mode.
switch (config)#radius-server key 0 test
switch (config)#radius-server authentication host 192.16.1.26
switch (config)#radius-server accounting host 192.16.1.26
switch (config)#aaa-accounting enable
switch (config)#aaa enable
switch (config)#aaa group server radius radius_aaa_1
switch config-sg-radius)# server 192.16.1.26
switch(config)#interface vlan 192
switch(config-if-vlan1)#ip address 192.16.1.50 255.255.255.0
switch(config)#free-resource 1 destination ipv4 192.16.1.26/32