User's Manual

Configuration Guide of XGS-5240-Series
59-10
Switch1 (config-cp-instance)#radius accounting
Switch1 (config-cp-instance)# radius-acct-server abc99
59.2.4 Accounting Function Troubleshooting
Encounter problems when using the accounting function, please check whether the
reasons are as follows:
 Whether launched the captive portal function and opened the portal configuration s
witch. Both the captive portal and the portal configuration should be open; otherwis
e, the captive portal function will not work, the client also cannot be redirect to the
specified page.
 The authentication server name of AAA module is same to the configured authentic
ation name of captive portal.
59.3 Free-resource Configuration
59.3.1
Introduction to Free-resource
Free-resource function is a method of captive portal module to achieve access the
free resources rule. By configuring the free-resource rules, one can makes certain the c
lient directly access the specific network resources without going through the portal aut
hentication.
59.3.2 Free-resource Configuration
1. Configure the free-resource rule
59.3.3 Free-resource Examples
Case：
Set up an environment as shown below. The IP is the address segment for the Cli
Command
Explanation
Config Mode
free-resource destination {ipv4 A.B.C.D/M |i
pv6 X:X:X:X/M}
[no] free-resource destination {ipv4 A.B.C.D
/M |ipv6 X:X:X:X/M}
Configure or delete the free-resour
ce rule.