User's Manual

Table Of Contents
Configuration Guide of XGS-5240-Series
48-6
48.4 The Number Limitation Function of MAC and I
P in Port, VLAN Troubleshooting Help
The number limitation function of MAC and IP in Port, VLAN is disabled by default,
if users need to limit the number of user accessing the network, they can enable it. If
the number limitation function of MAC address can not be configured, please check w
hether Spanning-tree, dot1x, TRUNK is running on the switch and whether the port is c
onfigured as a MAC-binding port. The number limitation function of MAC address is mu
tually exclusive to these configurations, so if the users need to enable the number limit
ation function of MAC address on the port, they should check these functions mentione
d above on this port are disabled.
If all the configurations are normal, after enabling the number limitation function of
MAC and IP in Port, VLAN, users can use debug commands to debug every limitation,
check the details of number limitations and judge whether the number limitation functio
n is correct. If there is any problem, please sent result to technical service center.