User's Manual

Configuration Guide of XGS-5240-Series
48-4
Command
Explanation
Port mode
switchport mac-address violation {prote
ct | shutdown} [recovery <5-3600>]
no switchport mac-address violation
Set the violation mode of the port, the
no command restores the violation m
ode to protect.
5. Display and debug the relative information of number limitation of MAC and IP
on ports
Command
Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic MAC i
n corresponding ports and VLAN.
show arp-dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic ARP i
n corresponding ports and VLAN.
show nd-dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic NEIGHB
OUR in corresponding ports and VLAN.
debug switchport mac count
no debug switchport mac count
All kinds of debug information when limi
ting the number of MAC on ports.
debug switchport arp count
no debug switchport arp count
All kinds of debug information when limi
ting the number of ARP on ports.
debug switchport nd count
no debug switchport nd count
All kinds of debug information when limi
ting the number of NEIGHBOUR on por
ts.
debug vlan mac count
no debug vlan mac count
All kinds of debug information when limi
ting the number of MAC in VLAN.
debug ip arp count
no debug ip arp count
All kinds of debug information when limi
ting the number of ARP in VLAN.
debug ipv6 nd count
no debug ipv6 nd count
All kinds of debug information when limi
ting the number of MAC in VLAN.