User's Manual

Table Of Contents
Configuration Guide of XGS-5240-Series
47-21
S authentication server, which has an IP address of 10.1.1.3, and use the default port
1812 for authentication and port 1813 for accounting. IEEE 802.1x authentication client
software is installed on the PC and is used in IEEE 802.1x authentication.
The configuration procedures are listed below:
Switch(config)#interface vlan 1
Switch(Config-if-vlan1)#ip address 10.1.1.2 255.255.255.0
Switch(Config-if-vlan1)#exit
Switch(config)#radius-server authentication host 10.1.1.3
Switch(config)#radius-server accounting host 10.1.1.3
Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/0/2
Switch(Config-If-Ethernet1/0/2)#dot1x enable
Switch(Config-If-Ethernet1/0/2)#dot1x port-control auto
Switch(Config-If-Ethernet1/0/2)#exit
47.3.3 Examples of IPv6 Radius Application
Fig 3-17 IPv6 Radius
Connect the computer to the interface 1/0/2 of the switch, and enable IEEE802.1x
on interface1/0/2. Use MAC based authentication. Configure the IP address of the switc
h as 2004:1:2:3::2, and connect the switch with any interface except interface 1/0/2 to t
he RADIUS authentication server. Configure the IP address of the RADIUS server to b
e 2004:1:2:3::3. Use the default ports 1812 and 1813 for authentication and accounting
2004:1:2:3::1
2004:1:2:3::2
Radius Server
2004:1:2:3::3