User's Manual

Configuration Guide of XGS-5240-Series
47-16
dot1x max-user userbased
<number>
no dot1x max-user userbas
ed
Set the upper limit of the number of users allowed ac
cessing the specified port, only used when the access
control mode of the port is userbased; the no comma
nd is used to reset the limit to 10 by default.
dot1x guest-vlan <vlanID>
no dot1x guest-vlan
Set the guest vlan of the specified port; the no comm
and is used to delete the guest vlan.
dot1x portbased mode sing
le-mode
no dot1x portbased mode
single-mode
Set the single-mode based on portbase authentication
mode; the no command disables this function.
3) Configure expanded 802.1x function
Command
Explanation
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
Enables the 802.1x address filter function in the switc
h; the no command disables the 802.1x address filter
function.
dot1x macbased port-down-
flush
no dot1x macbased port-do
wn-flush
Enables this command, when the dot1x certification ac
cording to mac is down, delete the user who passed t
he certification of the port; The no command does not
make the down operation.
dot1x accept-mac <mac-ad
dress> [interface <interface
-name> ]
no dot1x accept-mac <mac
-address> [interface <interf
ace-name> ]
Adds 802.1x address filter table entry, the no comman
d deletes 802.1x filter address table entries.
dot1x eapor enable
no dot1x eapor enable
Enables the EAP relay authentication function in the s
witch; the no command sets EAP local end authentica
tion.
4) Configure IPv6 passthrough function of the port
Command
Explanation
Port Mode
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
Enables IPv6 passthrough function of port on a switch,
only applicable when access control mode is userbas
ed; the no operation of this command will disable the
function.