User's Manual

Configuration Guide of XGS-5240-Series
45-7
(10) Configuring a numbered standard IPv6 access-list
(11) Configuring a numbered extended IPv6 access-list
(12) Configuring a standard IPv6 access-list based on nomenclature
a) Create a standard IPv6 access-list based on nomenclature
b) Specify multiple permit or deny rule entries
c) Exit ACL Configuration Mode
(13) Configuring an extended IPv6 access-list based on nomenclature.
a) Create an extensive IPv6 access-list based on nomenclature
b) Specify multiple permit or deny rule entries
c) Exit ACL Configuration Mode
2. Configuring the packet filtering function
(1) Enable global packet filtering function
(2) Configure ACL deny preemption function globally (optional)
3. Configuring time range function
(1) Create the name of the time range
(2) Configure periodic time range
(3) Configure absolute time range
4. Bind access-list to an incoming direction of the specified port
5. Clear the filtering information of the specified port
1. Configuring access-list
(1) Configuring a numbered standard IP access-list
Command
Explanation
Global Mode
access-list <num> {deny | permit} {{<sIpAddr> <s
Mask>} | any-source | {host-source <sIpAddr>}}
no access-list <num>
Creates a numbered standard
IP access-list, if the access-list
already exists, then a rule wil
l add to the current access-lis
t; the “no access-list <num>
“ command deletes a numbere
d standard IP access-list.
(2) Configuring a numbered extensive IP access-list
Command
Explanation
Global Mode