User's Manual

Configuration Guide of XGS-5240-Series
34
Step 4: Connect the Managed Switch to network devices.
Connect one end of a standard network cable to the 10/100/1000 RJ45 ports on the front of
the Managed Switch and connect the other end of the cable to the network devices such as
printer servers, workstations or routers, etc.
Connection to the Managed
Switch requires UTP Category 5 network cabling
with RJ
45 tips. For more information, please see the Cabling Specification in
Appendix A.
Step 5: Supply power to the Managed Switch.
Connect one end of the power cable to the Managed Switch.
Connect the power plug of the power cable to a standard wall outlet.
When the Managed Switch receives power, the Power LED should remain solid Green.
2.2.2 Rack Mounting
To install the Managed Switch in a 19-inch standard rack, please follow the instructions described
below:
Step 1: Place the Managed Switch on a hard flat surface, with the front panel positioned towards the
front side.
Step 2: Attach the rack-mount bracket to each side of the Managed Switch with supplied screws
attached to the package.
Figure 2-2-2 shows how to attach brackets to one side of the Managed Switch.
Figure 2-2-2 Attach brackets to the Managed Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the
parts by using incorrect screws would invalidate the warranty.