User's Manual

Configuration Guide of XGS-5240-Series
30-5
Switch(config-policymap-p1-class-c1)# set nested-vlan 1002
Switch(config-policymap-p1)#class c2
Switch(config-policymap-p1-class-c2)# set nested-vlan 2002
Switch(config-policymap-p1)#class c3
Switch(config-policymap-p1-class-c3)# set nested-vlan 3002
Switch(config-policymap-p1-class-c3)#exit
Switch(config-policymap-p1)#exit
Switch(config)#interface ethernet 1/0/1
Switch(config-if-ethernet1/0/1)# service-policy p1 in
30.4 Flexible QinQ Troubleshooting
If flexible QinQ policy can not be bound to the port, please check whether the problem is
caused by the following reasons:
 Make sure flexible QinQ whether supports the configured class-map and policy-map
 Make sure ACL includes permit rule if the class-map matches ACL rule
 Make sure the switch exists enough TCAM resource to send the binding