User's Manual

Configuration Guide of XGS-5240-Series
133
Switch1 (Config-If-Ethernet1/4)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/4)#exit
Switch1 (config)#load-balance enhanced profile
Switch1 (config-load-balance-enhanced-profile)# ipv4 field dst-ip
Switch1 (config)#interface port-channel 1
Switch1 (config-if-port-channel1)#load-balance enhance-profile
Switch2#config
Switch2 (config)#port-group 2
Switch2 (config)#interface ethernet 1/6
Switch2 (Config-If-Ethernet1/6)#port-group 2 mode on
Switch2 (Config-If-Ethernet1/6)#exit
Switch2 (config)#interface ethernet 1/8-10
Switch2 (Config-If-Port-Range)#port-group 2 mode on
Switch2 (Config-If-Port-Range)#exit
After configuration, PC1 sends the IP packets to PC2-PC5 at the same time. Because the
destination IP addresses of the packets are increasing by degrees, the packets will be
distributed to port 1-4 equally for achieving the flow sharing based on the destination IP
address.
14.6 Troubleshooting
14.6.1
Port Channel Troubleshooting
If problems occur when configuring port aggregation, please first check the following for
causes.
 Ensure all ports in a port group have the same properties, i.e., whether they are in
full-duplex mode, forced to the same speed, and have the same VLAN properties, etc. If
inconsistency occurs, make corrections.
 Some commands cannot be used on a port in port-channel, such as arp, bandwidth, ip,
ip-forward, etc.
14.6.2 Load Balance Troubleshooting
If problems occur when configuring Load Balance, please first check the following for causes.
 Check if the port-channel port aggregation is up by the command of show interface port
channel.