User's Manual

Configuration Guide of XGS-5240-Series
132
“on” mode and become an aggregated port respectively.
Scenario 3: Load Balance
Fig 6-4 Load Balance
As shown in the above figure, the port 5 of switch S1 is connected to PC1, port 1-4 of the
switch S2 are connected to PC2-PC5. All the ports of S1 and S2 are access ports.
Join the port 1-4 of S1 to group 1 with the method of on, join the port 5-8 of S2 to group 2
with the method of on. Configure the enhanced load balance template on S1 and apply it on
the interface port-channel 1.
The configuration steps are listed below:
Switch1#config
Switch1(config)#interface ethernet 1/1
Switch1(Config-If-Ethernet1/1)#port-group 1 mode on
Switch1(Config-If-Ethernet1/1)#exit
Switch1(config)#interface ethernet 1/2
Switch1 (Config-If-Ethernet1/2)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/2)#exit
Switch1 (config)#interface ethernet 1/3
Switch1 (Config-If-Ethernet1/3)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/3)#exit
Switch1 (config)#interface ethernet 1/4