Datasheet

WS-1032P
2
Layer 3 IP Routing Features
• IP dynamic routing protocol supports RIPv2, OSPFv2 and
OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
Layer2 Features
• High performance of Store-and-Forward architecture and
runt/CRClteringeliminateserroneouspacketstooptimize
the network bandwidth
• Storm Control support
– Broadcast/Multicast/Unknown unicast
• Supports VLAN
– IEEE 802.1Q tagged VLAN
– Supports provider bridging (VLAN Q-in-Q, IEEE
802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– Voice VLAN
– GVRP(GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
– STP, IEEE 802.1D Spanning Tree Protocol
– RSTP, IEEE 802.1w Rapid Spanning Tree Protocol
– MSTP, IEEE 802.1s Multiple Spanning Tree Protocol,
spanning tree by VLAN
– BPDU Guard
• Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol(LACP)
– Cisco ether-channel (static trunk)
– Maximum 5 trunk groups, up to 10 ports per trunk group
– Up to 56Gbps bandwidth (full duplex mode)
• Provide sport mirror (many-to-1)
• Portmirroringtomonitortheincomingoroutgoingtrafcon
a particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection (UDLD)
that monitors a link between two switches and blocks the
ports on both ends of the link if the link fails at any point
between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection
Switching)
Visualizing Wi-Fi Signals through Map
Importing your floor maps and locating each AP or AP group according to the
field deployment can save your time and cost of on-site support and monitoring.
It shows real-time AP status, and its signal heat map is capable of reflecting the
actual coverage and helps the administrator to fine-tune the overlapping of the
adjacent APs anytime to optimize the wireless network performance.
Control Room
Visualizing Wi-Fi Signals through Map
WLAN Controller
CH48
Tx: 70%
CH1
Tx: 70%
CH36
Tx: 100%
CH1
Tx: 100%
CH11
Tx: 100%
CH40
Tx: 50%
CH6
Tx: 35%
Maximal Scalability and Compatibility with Various Smart APs
To fulfill various business needs, the WS-1032P provides a maximum scalability
and is compatible with over 10 models of Smart APs from indoor to outdoor series
including ceiling-mount, wall-mount, in-wall, industrial, single-band, dual-band and
high-power access points which are able to adapt to different environments.