User's Manual

User’s Manual of WNRT-617
-80-
service ports (in XXX – YYY format, XXX is the start port number, YYY is
the end port number).
IP Address
The IP Address of the PC providing the service application.
Protocol
The protocol used for this application, either TCP, UDP, or All (all protocols
supported by the Router).
Status
The status of this entry either Enabled or Disabled.
To setup a virtual server entry:
Step 1. Click the Add New… button.
Step 2. Select the service you want to use from the Common Service Port list. If the Common
Service Port list does not have the service that you want to use, type the number of the service
port or service port range in the Service Port box.
Step 3. Type the IP Address of the computer in the IP Address box.
Step 4. Select the protocol used for this application, either TCP or UDP, or All.
Step 5. Select the Enable check box to enable the virtual server.
Step 6. Click the Save button.
Figure 5-39 Add or Modify a Virtual Server Entry
If your computer or server has more than one type of available service, please
select another service, and enter the same IP Address for that computer or
server.