User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
- EC Declaration of Conformity
User’s Manual of WNRT-617
-43-
To build a successful connection by WPS, you should also do the corresponding
configuration of the new device for WPS function.
I. By Push Button Configuration (PBC)
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods.
Step 1: Press the WPS/Reset Button on the front panel of the Router.
Figure 5-5 Hardware WPS/Reset Button
Or you can keep the default WPS Status as Enabled and click the Add device button in Figure 5-6,
then the follo
wing screen will appear.
Figure 5-6 Sof
tware WPS/Reset Button
Choose Press the button of the new device in two minutes, and click Connect.
When pressing and holding the WPS/Reset Button on the router for more than 5
seconds, you will reset the router.