User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
- EC Declaration of Conformity
User’s Manual of WNRT-617
-18-
LED Definition
Figure 2-2 WNR
T-617 Front Panel
LED Status Function
On Power is on.
PWR
Off Power is off.
On The Router is initializing.
Flashing The Router is working properly.
SYS
Off The Router has a system error.
Flashing The Wireless function is enabled.
WLAN
Off The Wireless function is disabled.
On A device is linked to the corresponding port but there is no activity.
Flashing An active device is linked to the corresponding port.
LAN1-4
Off No device is linked to the corresponding port.
On A device is linked to the corresponding port but there is no activity.
Flashing An active device is linked to the corresponding port.
WAN
Off No device is linked to the WAN port.
Slow Flashing
A wireless device is connecting to the network by WPS function. This
process will last for about 2 minutes.
On
A wireless device has been successfully added to the network by WPS
function. The LED will keep on for about 5 minutes.
WPS
Quick
Flashing
A wireless device has failed to be added to the network by WPS
function.
1. When a device has been successfully added to the network by WPS function, the
WPS LED will keep on for about 5 minutes and then turn off.
2. When pressing and holding the WPS/Reset Button for more than 5 seconds, you
will reset the router.