User's Manual

User’s Manual of WNRT-617
-96-
To add static routing entries:
Step 1. Click Add New… shown in Figure 5-50, you will see the following screen.
Figure 5-51 Add or Modify a Static Route Entry
Step 2. Enter the following data:
Object Description
Destination IP Address
The Destination IP Address is the address of the network or host that
you want to assign to a static route.
Subnet Mask
The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.
Gateway
This is the IP Address of the gateway device that allows for contact
between the Router and the network or host.
Status
Select Enabled or Disabled for this entry on the Status pull-down list.
Table 5-35
Step 3. Click the Save button to make the entry take effect.
Other configurations for the entries:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.