User Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Troubleshooting
- Appendix C: Frequently Asked Questions
User Manual of WNAP-6315
-125-
Step 7. Go to “Wireless WDS Settings” to configure the AP-1’s MAC address.
In
AP-1’s
WDS Setting, configure AP-2’s MAC address.
Step 8. If you select “Reboot Later”, you can click “Set Security” to continue to configure the encryption and
security key of the WDS connection.
Step 9. Click “Apply Changes” to apply the settings.
Step 10. Use command line tool to ping each other to ensure the link is successfully established.
From Site-1, ping 192.168.1.200; and in Site-2, ping 192.168.1.100.