User Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Troubleshooting
- Appendix C: Frequently Asked Questions
User Manual of WNAP-6315
-94-
Figure 5-65 Save/Reload Settings
The page includes the following fields:
Object Description
Save Settings to File Click the “Save…” button to back up the configuration of the WNAP-6315
and then save the “config.dat” in your computer.
Load Settings from File Select the configuration file of the WNAP-6315 and then click the “Upload”
button to reload the configuration back into the WNAP-6315.
Reset Settings to
Default
Click the “Reset” button to reset all settings of the WNAP-6315 to factory
default.
Factory Default Settings:
User Name: admin
Password: admin
IP Address: 192.168.1.253
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.253
DHCP: Disabled
SSID: WNAP-6315
Wireless Security: None
To activate your settings, you need to reboot the Wireless AP after you reset it.