User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-66-
5.6.3 Wireless MAC Filtering
Choose menu “Wireless→MAC Filtering”, and you can control the wireless access by configuring the Wireless
MAC Address Filtering function, shown in Figure 5-45. This function is not available when the operation is set to
Client.
Figure 5-45 Wireless MAC
Address Filtering
Wireless MAC Filtering：Click the Enable button to enable the Wireless MAC Address Filtering. The
default setting is disabled.
Filtering Rules：Select "Allow the stations specified by any enabled entries in the list to access.” if you
only want selected computers to have network access and all other computers not to have network access.
Select "Deny the stations specified by any enabled entries in the list to access." if you want all computers
to have network access except those computers in the list.
Add New…：Click “Add New…” to create a user profile to which wireless network access is denied or
allowed.
To add a Wireless MAC Address filtering entry, click the Add New… button. The "Add or Modify Wireless
MAC Address Filtering entry" page will appear, shown in Figure 5-46: