User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-52-
Step 4. You can go to Status page to check the repeater’s signal.
Figure 5-31 Client – Status
5.4 WPS
This section will guide you to adding a new wireless device quickly to an existing network by WPS (Wi-Fi
Protected Setup) function.
Step 1. Choose menu “WPS”, and you will see the next screen (shown in Figure 5-32 ). Click “Enable WPS”
button to enable the WPS function.
Figure 5-32 WPS
The page includes the following field
s:
Object Description
WPS Status
Enable or disable the WPS function here.
Current PIN
The current value of the AP's PIN displayed here. The default PIN of the AP can
be found in the label or User Guide.