User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-50-
Channel Width
The bandwidth of the wireless channel.
Enable Wireless Radio
The wireless radio of the AP can be enabled or disabled to allow or deny wireless
stations to access. If enabled, the wireless stations will be able to access the AP,
otherwise, wireless stations will not be able to access the AP.
Example of how to configure Client Mode. Please take the following steps:
To configure each wireless parameter, please go to the “Wireless → Wireless Settings” page.
Figure 5-27 Topology – Client Mode
Step 1. Click “Survey”.