User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-46-
Channel
This field determines which operating frequency will be used. It is not necessary
to change the wireless channel unless you notice interference problems with
another nearby access point.
Mode
This field determines the wireless mode which the AP works on.
Channel Width
The bandwidth of the wireless channel.
Enable Wireless Radio
The wireless radio of the AP can be enabled or disabled to allow or deny wireless
stations to access. If enabled, the wireless stations will be able to access the AP,
otherwise, wireless stations will not be able to access the AP.
Enable SSID Broadcast
If you select the Enable SSID Broadcast checkbox, the AP will broadcast its
name (SSID) on the air.
Disable Local Wireless
Access
If you select the Disable Local Wireless Access checkbox, the AP will deny
wireless stations to access, allowing only wired network while bridging with
remote AP.
Example of how to configure Bridge with AP Mode. Please take the following steps:
To configure each wireless parameter, please go to the “Wireless → Wireless Settings” page.
Figure 5-21 Topology - Bridge with AP
Step 1. Click “Survey”.