User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-44-
Figure 5-18 Repeater (Range Extender) – Security
Step 5. You can go to Status page to check the repeater’s signal.
Figure 5-19 Repeater (Range Extender) – Status
5.3.4 Operation Mode – Bridge with AP
Choose menu “Quick Setup → Next → Bridge with AP”, or “Operation Mode → Bridge with AP” to
configure the device as a general wireless access point with multiple SSIDs.
In this mode, the product can extend the coverage of another wireless Access Point or Router. The universal
repeater mode is for the wireless Access Point or Router which does not support WDS function.