User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-42-
function of the device in a region other than one of those specified in this field. If
your country or region is not listed, please contact your local government agency
for assistance.
Note: The country code selection is for non-US model only and is not
available to all US model. Per FCC regulation, all WiFi product marketed in
US must fixed to US operation channels only.
Channel Width
The bandwidth of the wireless channel.
Enable Wireless Radio
The wireless radio of the AP can be enabled or disabled to allow or deny wireless
stations to access. If enabled, the wireless stations will be able to access the AP,
otherwise, wireless stations will not be able to access the AP.
Example of how to configure Repeater Mode. The procedure of Universal Repeater and WDS Repeater
modes are the same. Please take the following steps:
To configure each wireless parameter, please go to the “Wireless → Wireless Settings” page.
Step 1. Select one of the Repeater Modes, and then click “Survey”.
Figure 5-15 Repeater (Range Extender) – Survey
Step 2. Click “Connect” to choose the root AP from the list to repeat the signal. If the root AP is not listed in
the table, click “Refresh” to update the list.