User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Factory Default Settings
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
User’s Manual of WNAP-1110
-36-
Example of how to configure Multi-SSID Mode. Please take the following steps:
To configure each wireless parameter, please go to the “Wireless → Wireless Settings” page.
Figure 5-7 Topology – Multi-SSID
1. Configuring the Access Point
Figure 5-8 Multi-SSID – Enable VLAN
Step 1. Select the checkbox “Enable VLAN” to enable VLAN function for this access point.