User Manual
Data Sheet
1
WGSW-52040
1
48-Port 10/100/1000Base-T + 4-Port 1000X SFP
Managed Gigabit Switch
Telecom-class Gigabit Solution for Enterprise Backbone and Data Center
Networking
PLANET WGSW-52040 is a Layer 2 managed Gigabit Switch that provides high-density
performance and supports static Layer 3 routing. With 104Gbps switching fabric, the
WGSW-52040 can handle extremely large amounts of data in a secure topology linking
to an enterprise backbone or high capacity servers. The powerful WRR (Weighted
Round Robin) and Network Security features make the WGSW-52040 perform
effective data traffic control for ISP and Enterprise VoIP, video streaming and multicast
applications.
Abundant IPv6 Support
The WGSW-52040 provides IPv6 management and enterprise level secure features
such as SSH, ACL, WRR and RADIUS authentication besides support of the IPv4
protocol. The WGSW-52040 thus helps the enterprises to step in the IPv6 era with the
lowest investment. In addition, you don’t need to replace the network facilities when the
IPv6 FTTx edge network is built.
High Performance
The WGSW-52040 provides 48 10/100/1000Mbps Gigabit Ethernet ports with 4 Gigabit
SFP slots. It boasts a high-performance switch architecture that is capable of providing
non-blocking switch fabric and wire-speed throughput as high as 104Gbps, which greatly
simplies the tasks of upgrading the LAN for catering to increasing bandwidth demands.
Physical Port
• 48-Port 10/100/1000Base-T Gigabit Ethernet RJ-45
• 4 100/1000Base-X mini-GBIC/SFP slots, SFP type auto
detection
• RJ-45 to DB9 console interface for Switch basic
management and setup
IP Stacking
• Connects with stack member via both Gigabit TP and SFP
interfaces
• Single IP address management, supports up to 24 units
stacked together
• Stacking architecture supports Chain and Ring mode
IP Routing Features
• Supports maximum 128 static routes and route
summarization
Layer 2 Features
• Complies with the IEEE 802.3, IEEE 802.3u, IEEE
802.3ab, IEEE 802.3z Gigabit Ethernet standard
• Supports Auto-negotiation and Half-Duplex / Full-Duplex
modes for all 10Base-T/100Base-TX and 1000Base-T ports
• Supports 100/1000Base-X for all SFP interfaces
• Auto-MDI/MDI-X detection on each RJ-45 port
• Prevents packet loss Flow Control
–
IEEE 802.3x PAUSE Frame ow control for Full-Duplex
mode
–
Back-Pressure Flow Control in Half-Duplex mode
• High performance Store and Forward architecture,
broadcast storm control, port loopback detect
• 16K MAC address table, automatic source address learning
and ageing
• Supports VLAN
–
IEEE 802.1Q Tag-based VLAN
–
GVRP for dynamic VLAN Management
–
Up to 256 VLANs groups, out of 4041 VLAN IDs
–
Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
–
Private VLAN Edge (PVE) supported
–
GVRP protocol for Management VLAN
48 x 10/100/1000 Base-T, RJ-45 Ports 4 x 100/1000 Base-X SFP Slots
RJ-45-to-DB9 Console