User Manual

User’s Manual of WGSW-24040 / WGSW-24040R
6.22 sFlow Command
sFlow Configuration
Description:
Show global and per port sFlow configuration.
Syntax:
sFlow Configuration
sFlow Receiver
Description:
Set or show the sFlow receiver timeout, IP address, and UDP port.
Syntax:
sFlow Receiver [release] [<timeout>] [<ip_addr_host>] [<udp_port>] [<datagram_size>]
Parameters:
release : Release the current owner of the receiver.
The owner can either be "<none>" if the receiver is not currently owned by anyone, it can be
"<Configured through local management>" if it's currently set up by CLI or Web, or it can be anything
else if is set-up through SNMP. You can only (re-)configure the receiver if it is not currently owned by
anyone or owned by CLI or Web. If this argument is specified, the remaining arguments are ignored.
<timeout> : Receiver timeout measured in seconds. The switch decrements the timeout once per second, and as
long as it is non-zero, the receiver receives samples. Once the timeout reaches 0, the receiver and all
its configuration is reset to defaults. Valid range is 0 - 2147483647 seconds.
<ip_addr_host> : IPv4/IPv6 address or a hostname identifying the receiver.
<udp_port> : Receiver's UDP port. Valid range is 0 - 65535.
Use 0 to get default port (which is 6343).
<datagram_size>: Maximum datagram size. Valid range is 200 - 1468 bytes.
Default is 1400 bytes.
sFlow FlowSampler
Description:
Set or show flow sampler configuration per port.
When operational, the sampling rate 'N' is rounded off to the nearest supported value.
539