(V3) Datasheet

2
WGSW-20160HP/WGSW-24040HP4
• High performance of Store-and-Forward architecture and
runt/CRClteringeliminateserroneouspacketstooptimize
the network bandwidth
• Storm Control support
– Broadcast/Multicast/Unicast
• Supports VLAN
– IEEE 802.1Q tagged VLAN
– Up to 4K VLANs groups, out of 4094 VLAN IDs
– Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Port Isolation
– MAC-based VLAN
– IP Subnet-based VLAN
– Protocol-based VLAN
– VLAN Translation
– Voice VLAN
– GVRP
• Supports Spanning Tree Protocol
– IEEE 802.1D Spanning Tree Protocol
– IEEE 802.1w Rapid Spanning Tree Protocol
– IEEE 802.1s Multiple Spanning Tree Protocol, spanning
tree by VLAN
– BPDU Filtering/BPDU Guard
• Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 10/12 trunk groups, up to 4 ports per trunk
group
– Up to 8Gbps bandwidth (full duplex mode)
• Provides port mirror (many-to-1)
• Portmirroringtomonitortheincomingoroutgoingtrafcon
a particular port
• Loop protection to avoid broadcast loops
• Compatible with Cisco uni-directional link detection(UDLD)
that monitors a link between two switches and blocks the
ports on both ends of the link if the link fails at any point
between the two devices
• Provides ONVIF for co-operating with PLANET video IP
surveillances
Layer 3 IP Routing Features
• Supportsmaximum32staticroutesandroutesummarization
Quality of Service
• Ingress Shaper and Egress Rate Limit per port bandwidth
control
Built-in Unique PoE Functions for Surveillance Management
As a managed PoE Switch for surveillance network, the WGSW-20160HP and
WGSW-24040HP4 feature the following intelligent PoE management functions:
■PoESchedule
■PDAliveCheck
■ScheduledPowerRecycling
■SMTP/SNMPTrapEventAlert
PoE Schedule for Energy Saving
Besides being used for IP surveillance, the WGSW-20160HP and WGSW-24040HP4
are certainly applicable to build any PoE network including VoIP and wireless LAN.
Under the trend of energy saving worldwide and contributing to the environmental
protection on the Earth, the WGSW-20160HP and WGSW-24040HP4 can effectively
control the power supply besides its capability of giving high watts power. The “PoE
schedule” function helps you to enable or disable PoE power feeding for each PoE
port during specified time intervals and it is a powerful function to help SMBs and
enterprises save energy and budget.
Intelligent Powered Device Alive Check
The WGSW-20160HP and WGSW-24040HP4 can be configured to monitor a
connected PD status in real time via ping action. Once the PD stops working and it
is without response, the WGSW-20160HP and WGSW-24040HP4 will resume the
PoE port power and bring the PD back to work. It will greatly enhance the network
reliability through the PoE port resetting the PD’s power source, thus reducing
administrator management burden.
PT PoE Camera
Ping Request
Ping Request
Check alive status for 3 times
Restart PoE device if without response
Ping Echo
No Response......
PD Alive!!
Step 1
Step 3
Step 2
Step 4
ON
PoE
ON
ON
PoE
OFF
PD Status
Good!!
Alarm Notification