WGS-5225-Series Quick Guide

6
3.1 Terminal Block Connector Pinout
To install the 3-pin Terminal Block Connector on the Wall-mount Managed Switch,
simplyfollowthefollowingsteps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into V-,
andgroundingwireintoGround.
V+
V
-
Ground
Step 2: Tighten the wire-clamp screws for preventing the wires from loosening
andplugthemintotheWall-mountManagedswitch
Note
1.Thewiregaugeshouldbeintherangefrom12to24AWG.
2.Thedevicemustbegrounded.