WGS-5225-Series Quick Guide

13
6. Telnet Login
The Wall-mount Managed Switch also supports telnet for remote management.
The switch asks for user name and password for remote login when using telnet;
pleaseuse“admin”forbothusernameandpassword.
DefaultIPAddress:192.168.0.100
Username:admin
Password:admin
Figure 6-1: Wall-mount Managed Switch Telnet Login Screen
The user can now enter commands to manage the Wall-mount Managed Switch.
Foradetaileddescriptionofthecommands,pleaserefertothefollowingchapters.
Note
1.Forsecurity reason, please change and memorize the new pass-
wordafterthisfirstsetup.
2.Only accept command in lowercase letter under console inter-
face.
6.1 ConguringIPAddress
TheWall-mountManagedSwitchisshippedwithdefaultIPaddressshownbelow:
IPAddress:192.168.0.100
SubnetMask:255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please
usetheprocedureasfollows: