User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of WGS Managed Series
The page includes the following fields:
Object Description
Session ID
Set the port mirror session ID.
Possible ID are: 1 to 4.
Monitor Session State
Enable or disable the port mirroring function.
Select the port to mirror destination port.
Destination Port
F
rames from ports that have either source (rx) or destination (tx) mirroring enabled are
mirrored to this port.
Allow-ingress
F
rames transmitted from these ports are mirrored to the mirroring port. Frames received
are not mirrored.
Sniffer TX Ports
Sniffer RX Ports
Frames received at these ports are mirrored to the mirroring port.
Frames transmitted are not mirrored.
Buttons
: Click to apply changes.
Figure 4-3-10 Mirroring Status Page Screenshot
The page includes the following fields:
Object Description
Displ
ay the session ID
Session ID
T
his is the mirroring port entry
Destination Port
Displ
ay the ingress state
Ingress State
Displ
ay the current TX ports
Source TX Port
Displ
ay the current RX ports
Source RX Port
95