User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of WGS Managed Series
34
WGS-4215-8P2S LED Indication
Figure 2-1-2d WGS-4215-8P2S LED Panel
■ System
LED Color Function
Lights to indicate that the Switch has power.
PWR Green
Blinks to indicate the system of the Switch is booting
■ PoE 10/100/1000BASE-T Interfaces (Port-1 to Port-8)
LED Color Function
Lights:
To indicate the link through that port is successfully established.
LNK/ACT Green
Blinks:
To indicate that the switch is actively sending or receiving data over that port.
Lights:
To indicate the port is providing DC in-line power.
PoE Orange
Off:
To indicate the connected device is not a PoE Powered Device (PD)
Per 100/1000X SFP Interface (Port9 to Port10)
LED Color Function
Lights: It indicates the link through that port is successfully established at 1000Mbps.
1000
LNK/ACT
Green
Blinks: It indicates that the Switch is actively sending or receiving data over that port.
Lights: It indicates the link through that port is successfully established at 100Mbps.
100
LNK/ACT
Orange
Blinks: It indicates that the Switch is actively sending or receiving data over that port.