User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of WGS Managed Series
4.12.8 LLDP Overloading
The LLDP Port Overloading screen in Figure 4-12-16 appears.
Figure 4-12-16 LLDP Port Overloading Table Page Screenshot
The page includes the following fields:
Object Description
T
he switch port number of the logical port
Interface
T
otal number of bytes of LLDP information that is normally sent in a packet
Total (Bytes)
T
otal number of available bytes that can also send LLDP information in a packet
Left to Send (Bytes)
Gives the st
atus of the TLVs
Status
Displ
ays if the mandatory group of TLVs were transmitted or overloaded
Mandatory TLVs
Displ
ays if the capabilities packets were transmitted or overloaded
MED Capabilities
Displ
ays if the location packets were transmitted or overloaded
MED Location
MED Network Policy
Displays if the network policies packets were transmitted or overloaded
MED Extended Power
via MDI
Displays if the extended power via MDI packets were transmitted or overloaded
802.3 TLVs
Displays if the 802.3 TLVs were transmitted or overloaded
315