WGS-4215-Series User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of WGS Managed Series
247
The page includes the following fields:
Object Description
• Access Profile Name
(1-32 characters)
Indicates the access profile name
• Priority (1-65535)
Set priority
The allowed value is from 1 to 65535
• Management Method
Indicates the host can access the switch from
HTTP/HTTPs/telnet/SSH/SNMP/All interface that the host IP address matched
the entry.
• Action
An IP address can contain any combination of permit or deny rules.
(Default: Permit rules)Sets the access mode of the profile; either permit or
deny.
• Port
Select port from this drop-down list
• IP-Source
Indicates the IP address for the access management entry
Buttons
: Click to apply changes.
Figure 4-9-29 Profile Rule Table Page Screenshot
The page includes the following fields:
Object Description
• Access Profile Name
Display the current access profile name
• Priority
Display the current priority
• Management Method
Display the current management method
• Action
Display the current action
• Port
Display the current port list
• Source IPv4
Display the current source IPv4 address
• Source IPv4 Mask
Display the current source IPv4 mask