User's Manual

User’s Manual of WGR-500
70
4.4.4 IP Filtering
IP Filtering is used to block internet or network access to specific IP addresses on your local network as shown in
Figure 4-41. The restricted user may still be able to log in to the network but will not be able to access the internet.
To begin blocking access to an IP address, enable IP Filtering and enter the IP address of the user you wish to
block.
Figure 4-41: IP Filtering
Object Description
Enable IP Filtering
Check this box to enable IP Filter function
Enable IPv4
Check this box to enable IP filtering method using IPv4.
Enable IPv6
Check this box to enable IP filtering method using IPv6.
Local IP Address
Add LAN IP address you want to control
Protocol
Select the port number protocol type (TCP, UDP or both).
If you are unsure, then leave it to the default both protocol
Comment
Enter the description for this setting.