User's Manual

User’s Manual of WGR-500
52
4.3.2 LAN Setup
This page is used to configure the parameters for local area network which connects to the LAN port of your
industrial wall-mount Gigabit router as shown in Figure 4-27. Here you may change the setting for IP address,
subnet mask, DHCP, etc.
Figure 4-27: LAN Setup
Object Description
IP Address
The LAN IP address of the Industrial wall-mount Gigabit router and default is
192.168.1.1. You can change it according to your request.
Subnet Mask Default is 255.255.255.0. You can change it according to your request.
DHCP
You can select one of them -- Disable, Client, or Server. Default is Server,
where the industrial wall-mount Gigabit router can assign IP addresses to
the computers automatically.
DHCP Client Range
For the Server mode, you must enter the DHCP client IP address range in
the field. And you can click the “Show Client” button to show the Active
DHCP Client Table.
Domain Name
Default is Planet.
802.1d Spanning Tree
You can enable or disable the spanning tree function.
Clone MAC Address
You can input an MAC address here for using clone function.
If you change the device’s LAN IP address, you must enter the new one in your browser to
get back to the web-based configuration utility. And LAN PCs’ gateway must be set to this
new IP for successful Internet connection.