User's Manual

User’s Manual of WGR-500
36
Figure 4-10: Setup Wizard – LAN Configuration
Object Description
IP Address Enter the IP address of your Router. The default: 192.168.1.1
Subnet Mask
An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
Step 5 WAN Interface Setting
The industrial wall-mount Gigabit Router supports five access modes in the WAN side as shown in Figure 4-11.
Please choose the correct mode according to your ISP.
Figure 4-11: Setup Wizard – WAN Configuration
Mode 1 - Static IP
Select Static IP Address if all the Internet port’s IP information is provided to you by your ISP. You will need to
enter the IP address, subnet mask, gateway address, and DNS address provided to you by your ISP. Each IP
address entered in the fields must be in the appropriate IP form, which are four octets separated by a dot (x.x.x.x).
The Router will not accept the IP address if it is not in this format. The setup is shown in Figure 4-12.