WGR-500-Series User Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
88
4.6.1 Connection Test
The page is allows you to issue ICMP PING packets to troubleshoot IP connectivity issues. After you press “Ping”,
5 ICMP packets are transmitted, and the sequence number and roundtrip time are displayed upon reception of a
reply. The Page refreshes automatically until responses to all packets are received, or until a timeout occurs. The
ICMP Ping is shown in Figure 4-53.
Figure 4-53: Ping
Object Description
IP Address The destination IP Address.
Counts The time of ping.
Be sure the target IP address is within the same network subnet of the industrial wall-
mount
Gigabit router, or you have to set up the correct gateway IP address.