User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
73
4.4.4 IP Filtering
IP Filtering is used to block internet or network access to specific IP addresses on your local network as shown in
Figure 4-41. The restricted user may still be able to log in to the network but will not be able to access the internet.
To begin blocking access to an IP address, enable IP Filtering and enter the IP address of the user you wish to
block.
Figure 4-41: IP Filtering
Object
Description
Enable IP Filtering Check this box to enable IP Filter function
Enable IPv4 Check this box to enable IP filtering method using IPv4.
Enable IPv6 Check this box to enable IP filtering method using IPv6.
Local IP Address Add LAN IP address you want to control
Protocol
Select the port number protocol type (TCP, UDP or both).
If you are unsure, then leave it to the default both protocol
Comment Enter the description for this setting.