User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
62
4.3.7 IPv6 LAN Setting
IPv6 LAN Setting will be only available if you enable IPv6 WAN. Make sure IPv6 WAN is enabled before you could
configure the IPv6 LAN. The setup is shown in Figure 4-33.
Figure 4-33: IPv6 LAN Setup
Object
Description
Enable IPv6 LAN Click this box to enable IPv6 LAN configuration.
DNS Address Enter IPv6 DNS Address assigned by your ISP.
Interface Name Enter assigned Interface name of the IPv6 LAN port.
From Enter assigned starting Address pool.
To Enter assigned ending Address pool.