User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
57
4.3.4 Route
There are two route types that are Dynamic Route and Static Route. Please refer to the following sections for the
details as shown in Figure 4-29.
Figure 4-29: Routing setup
■ Dynamic routing
Dynamic routing is a networking technique that provides optimal data routing. Unlike static routing, dynamic
routing enables routers to select paths according to real-time logical network layout changes. RIPng exchanges
routing information used to compute routes and is intended for IP version 6 (IPv6)-based networks while RIPv1
and RIPv2 is intended for IP version 4 (IPv4)-based networks.
Object Description
Enable Dynamic Route Click this box to enable Dynamic Route.
NAT Enable or Disable NAT function
RIP Send
Disable:do not send any RIP packet out
RIP1: Send RIP1 packet out
RIP2. Send RIP2 packet out
RIP Recv
Disable：do not receive any RIP packet
RIP1: Only receive RIP1 packet
RIP2: Only receive RIP2 packet
RIPng Enable or Disable RIPng function