User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
40
Mode 2 DHCP Client
Select DHCP Client to obtain IP Address information automatically from your ISP. The setup is shown in Figure
4-13.
Figure 4-13: WAN Interface Setup – DHCP Setup
Mode 3 PPPoE
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will
provide you with a username and password. This option is typically used for DSL services. The setup is shown in
Figure 4-14.
Figure 4-14: WAN Interface Setup – PPPoE Setup
Object Description
User Name Enter your PPPoE user name.
Password Enter your PPPoE password.