User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
Userâs Manual of WGR-500-4P and WGR-500-4PV
39
Step 5 WAN Interface Setting
The industrial wall-mount Gigabit Router supports five access modes in the WAN side as shown in Figure 4-11.
Please choose the correct mode according to your ISP.
Figure 4-11: Setup Wizard â WAN Configuration
Mode 1 - Static IP
Select Static IP Address if all the Internet portâs IP information is provided to you by your ISP. You will need to
enter the IP address, subnet mask, gateway address, and DNS address provided to you by your ISP. Each IP
address entered in the fields must be in the appropriate IP form, which are four octets separated by a dot (x.x.x.x).
The Router will not accept the IP address if it is not in this format. The setup is shown in Figure 4-12.
Figure 4-12: WAN Interface Setup â Static IP Setup
Object Description
IP Address Enter the IP address assigned by your ISP.
Subnet Mask Enter the Subnet Mask assigned by your ISP.
Default Gateway Enter the Gateway assigned by your ISP.
DNS The DNS server information will be supplied by your ISP.